Your Cart (0)
Your cart is empty
Tax included and shipping calculated at checkout
Installation manual · English
GD10 66 × 72 in. Installation Manual
Revision: Unverified
Applies to: GD10-BM-6672, GD10-BG-6672, GD10-BR-6672, GD10-CHR-6672
Shower Doors · Tub Doors
GD10 Sliding Glass Shower Door Installation Guide
Use this guide for GD10 round-rail single-sliding shower and tub door models. The available PDF is limited to GD10 66 × 72 in. models and must not be applied to other sizes.
Prepare first
Before Installation
Pre-installation checklist
- Match every carton label and manual to the exact model number before opening hardware bags.
- Measure the finished opening at the top, middle, and bottom; confirm the walls are within the model's adjustment range.
- Confirm the threshold is level, clean, dry, and wide enough for the bottom track.
- Identify plumbing or electrical lines before drilling.
- Lay glass panels on padded supports and keep corner protectors installed until required.
Tools you may need
- Tape measure
- 4 ft. level
- Pencil
- Drill and suitable bits
- Phillips screwdriver
- Hex keys
- Utility knife
- 100% bathroom silicone and caulk gun
- Safety glasses and cut-resistant gloves
- A second adult helper
Safety note: Tempered glass is heavy and vulnerable at its edges. Use two adults, wear eye and hand protection, support panels on padded blocks, and never place glass directly on tile or concrete. Stop and contact support if the opening is out of square or any glass edge is damaged.
Video checkpoints
Key Installation Steps
Use these checkpoints with the complete video and exact model manual.
-
00:00
Confirm model, handing, and parts
Match the carton label to the GD10 series and organize the round-rail hardware.
-
00:24
Measure and mark the opening
Verify finished width, height, level, and wall plumb before making any holes.
-
00:52
Install wall profiles and rail supports
Drill the marked locations and secure the structural wall components.
-
01:24
Position the fixed glass
Lift the fixed panel with a helper and seat it in the correct profile and guide.
-
02:00
Hang the sliding panel
Install rollers and place the sliding glass on the rail while protecting glass edges.
-
02:38
Install guides, seals, and handle
Fit the bottom guide, stops, seals, and handle without overtightening.
-
03:18
Adjust travel and alignment
Tune roller height and stops so the panel closes evenly and moves freely.
-
03:52
Seal and perform final checks
Apply silicone only where shown and verify operation before observing cure time.
Documents
Manuals & Applicable Models
Download only the document that lists your complete model number.
Troubleshooting
Frequently Asked Questions
Can I install the door on an out-of-plumb wall?
Measure the opening at the top, middle, and bottom and compare the variation with the adjustment range for your exact model. Review the uneven-wall guide or contact support before drilling.
Can one person install this shower door?
No. Glass panels are heavy and require at least two adults for lifting, positioning, and alignment.
When can I use the shower after sealing?
Follow the cure time printed on the silicone product, typically at least 24 hours, before exposing the enclosure to water.
Which manual should I download?
Match the full model number, including width, height, finish, and any TP or LS prefix, to the applicable-model list beside each manual.
What should I do if a part is missing?
Stop installation, photograph the carton label and parts received, and contact Cozy N Bath installation support with the full model number.
Continue